ge motion sensor light bulb instructions

You could be using version 2.7 or earlier of the C by GE firmware, in which case you have to run through an entirely different reset process. And this is where your eyeballs may start twitching. And if so you'll have to do it all over again until you are capable of following simple instructions, OK, buddy?īut there is another explanation. What if it doesn't? What about if, during the fourth cycle, you panicked and turned it off after just seven seconds? What if you left it off for too long? Will you get the three flashes? At which point it should flash three times, indicating the reset has worked. That's five seconds, OK? And then at the end of the sequence, turn it on one last time. Before you start the process, make sure the light is off for at least five seconds. No less than five times.Īnd then, just to make it even more maddening, the engineer in charge of this obsessive video decided to add even more unnecessary precision. But the video is adamant: eight seconds on, two seconds off. This is not a tightly engineered device it's a light bulb. Most likely, the reset process will work anywhere between 5-10 seconds on and 1-4 seconds off. Now, we very much doubt the timings have to be this precise. But you have to turn it off for two seconds. And in between each on cycle, you turn it off. There is even a clock on the video to illustrate this eight-second rule. You have to turn it on for eight seconds. And we haven't even got to the precise timing yet. No one should have to go to this much trouble to reset a fucking light bulb. Which is great but that fourth and then fifth cycle turns a simple reset into a logistical nightmare that takes an entire minute and requires you to be constantly vigilant. And then, just to be really, really, sure, a fifth cycle. It is just about feasible that someone could do that by mistake. You can see how that might require three cycles: on/off, on/off, on/off. How many engineers does it take to reset a light bulb? Obviously the engineers want to make sure that a light bulb isn't accidentally reset through normal use. Which seems a little excessive straight off the bat.

Put most simply, the factory reset is achieved by cycling the light on and off five times. Not only that, but they have unwittingly created a video that, in its effort to be super clear, walks through the entire process slowly and in real time, and somehow makes three minutes stretch into an infinity of tedium.

Ge motion sensor light bulb instructions